#When did photoshop cs2 come out manual
#When did photoshop cs2 come out software

My gut feeling is that this ( the above 'feature') is somehow related to the new CS2 layout function for shuttle and fiddle-yard. Updated to 4.2.8 and the symptom reappeared - and stayed evident when reloaded to 4.2.9

I have regressed to 4.2.0 and did not see the problem (limited testing by confidence is high) In some cases transfos may cause problems (transfer electrical noise on the mains into the secondary circuit). What is your CS2 source of power? (I use a 60101 100 W switching power supply).

#When did photoshop cs2 come out manual

some command strings in memory activated inadvertently: to test this set all 'memories' in manual mode only and see if the behavior disappears. forgotten shuttle operation that triggers itself (easy to check on the loco's speedo) CS2 hardware problems or need to reload the last version Yes, sometime the digital signal may be distorted (short circuit, capacitor, overload) and cause an unwanted actions but in your case to have a loco 'set off at low speed' and the speedo showing the speed is a phenomenon inside the CS2 which may be caused by: On my HO 3 rails layout I have only MFX locos 33 of them and most have more than 4 functions some even have more than 16.

#When did photoshop cs2 come out software

I have 2 CS2s (60215) both with the latest software 4.2.9 (0) and I use them a lot since 2012. Its not the end of the world and if the answer contains words like DCC and other technical mysteries I shall simply live with it! So what is 'wrong' or what have I unknowingly set up. The lok goes in the direction it was last set for. The speedo show the speed and the lok can now be stopped or controlled as wished. Switch on the lights then switch on F4 the main beam headlights and they come as expected then a second or so later the lok sets off at a low speed (20ish) without touching any thing else. So my lovely Re6 swiss lok sitting in the siding ready to go. In fact it happens with all registered loks regardless of scale providing they have more than five functions.

I have raised this topic before and as it happened whilst operating an LGB lok I was either ignored or put on the loopy list. does the same happen if the left v right throttle/buttns are used? What hardware version of the CS2 do you have (and the software version for that matter) something in the CS2 causes something else to happen. Its not the end of the world and if the answer contains words like DCC and other technical mysteries I shall simply live with it!ДЄ bit more observational details may help, however I am reminded of the design issue of the early CS2 where turning the right throttle resulted in the Loco menu popping up. The lok goes in the direction it was last set for. The speedo show the speed and the lok can now be stopped or controlled as wished. then a second or so later the lok sets off at a low speed (20ish) without touching any thing else.

the main beam headlights and they come as expected So my lovely Re6 swiss lok sitting in the siding ready to go.